|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
DX-V88W
� Press the ON/STAND-BY button. Is 7 seg LED displayed ? Yes Is the SHARP logo screen displayed ? No Yes "The SHARP logo is not displayed." "7 seg LED is not displayed."
No
Is "ERROR" displayed ? No Can the tray be open or closed, and can the disc be changed ? Yes Is No Disc displayed ? No Can a Video CD be played ? Yes Can the Audio signal be heard ?
Yes
"ERROR is displayed."
No
"The changer mechanism is malfunctioning."
"No Disc is displayed." Yes
No
"The Video CD cannot be played normally."
"No sound is heard." No
Yes Is an audio signal being output from the microphone ? No Yes The microphone signal is not being output.
End
� The SHARP logo is not displayed.
Is the voltage on pin 52 (VREF) on IC14 (IS3209) about 1.3 V ? Yes Is a 13.5 MHz clock signal available at pin 79 (PCLK) on IC14 ?
No
Check D103, C150 and R128.
Check the soldering on IC14 and the voltage at each pin. No
Yes Is the signal shown in waveform drawing 8, 9 and 10 being supplied to pin 82 (HSYNC), pin 84 (VSYNC) and pin 86 (YUV7) on IC14 ? Yes Is a video signal available at pin 64 (VDAC) on IC14 ? Yes Check the terminal PWB connector and each transistor. No Check the soldering at pin 64 on IC14, and at R126 and R178. If there is no problem, IC14 is defective. Check the soldering on IC15 (ES3210) and IC16 (4M DRAM) and the voltage at each pin.
No
� 31 �
|
|
|
> |
|
