|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
More than pleased with my prurchase, very good product for the price.
;
Manual-link came 30 minutes after having paid for an extremely rare (40 years old) item (sony icr-120) and helped me to get the radio rework again. So really good help for me, fast and reliable delivery and -taken that into consideration- a very reasonable price for that service. So thanks again! Mike, Germany
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
TEST AND MEASUREMENT
2.
igure 23 Using the spectru analyser easure the i age leak ratio I age leak ratio is the easure ratio o peak po er an the po er at 135k belo peak re uency E a ple peak po er 902 468 h 33 po er at 135k belo peak po er -9 i age leak ratio 33 - -9 42
Figure 23: I age leak ratio 3. I i age leak ratio is greater than 30 c then unit is K o set calibration is co plete 4. I i age leak ratio is less than 30 c then go to Ich gain calibration
500-0723
IQch Gain Calibration
1. Set I ch gain to 0 a b c n the C press 6 ress E TER ress E TER igure 21 ress ove le t arro until I C GAI iel is highlighte igure 22 Enter 2 into the ata iel
2. Measure the i age leak ratio 3. I i age leak ratio is greater than 30 c then unit is K o set calibration is co plete 4. I i age leak ratio is less than 30 c then repeat steps 1 2 an 3 above ith I ch gain values 1 2 3 4 5 6 an 7 5. I i age leak ratio is still less than 30 c then go to ch gain calibration
MCUK970901C8 Service Manual
Section 7 7 - 17
Issue 1 Revision 0
|
|
|
> |
|
