|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
TEST AND MEASUREMENT
2.
igure 23 Using the spectru analyser easure the i age leak ratio I age leak ratio is the easure ratio o peak po er an the po er at 135k belo peak re uency E a ple peak po er 902 468 h 33 po er at 135k belo peak po er -9 i age leak ratio 33 - -9 42
Figure 23: I age leak ratio 3. I i age leak ratio is greater than 30 c then unit is K o set calibration is co plete 4. I i age leak ratio is less than 30 c then go to Ich gain calibration
500-0723
IQch Gain Calibration
1. Set I ch gain to 0 a b c n the C press 6 ress E TER ress E TER igure 21 ress ove le t arro until I C GAI iel is highlighte igure 22 Enter 2 into the ata iel
2. Measure the i age leak ratio 3. I i age leak ratio is greater than 30 c then unit is K o set calibration is co plete 4. I i age leak ratio is less than 30 c then repeat steps 1 2 an 3 above ith I ch gain values 1 2 3 4 5 6 an 7 5. I i age leak ratio is still less than 30 c then go to ch gain calibration
MCUK970901C8 Service Manual
Section 7 7 - 17
Issue 1 Revision 0
|
|
|
> |
|
