|
There are currently no product reviews.
 ;
Was very fast and accurate service. Just what I needed. I recommend to everyone.
 ;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
Power Level Calibration
Before starting Power Level Calibration, the Power Ramp Editor should be enabled. The mobile should be connected to GSM Tester or Power Meter.
1. Select the required Band and PA Level, and click the "Get" button. The default ramping value for the selected band and PA Level will be displayed. 2. Input the Tx ARFCN (EGSM = 45 ch, DCS = 633 ch ), and press Enter key. 3. Check the "Burst Tx" of the RF Mode. The handset will transmit and the power meter will display the default Tx power level.
NOTE: To stop the handset transmitting, click "General off".
� 8-13 �
|
