|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
;
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
 ;
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
;
Quick response and exactly what I was looking for and at a great fair price!
;
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Removal
and cleaning unit
of interior with panels
components: removed.
Do not operate
I
--
5. Wash the interior components you have just removed with mild soap or detergent and warm water. Rinse in clean water. Sanitize in a solution of l/402. (8 ml) of chlorine laundry bleach mixed with 1 gallon (3.8 L) warm water.
NOTE:
Do not wash plastic Plastic parts can not withstand 145� F (63°C).
parts in dishwasher. temperatures above
6. Wash the storage bin, door, gasket, and ice scoop with mlld soap or detergent and warm water. Rinse with clean water. Sanitize with the chlorine bleach and water solution.
FIGURE 6
1. Remove ice retainer baffle by flexing and then slide it off the studs.
it (Figure
6) 7. Replace the interior components: water utor, hoses, water pan, and ice retainer. distrib-
8. Check
l l
the following: water valve is in water pan. (Figure holes and into 7). are water storage
Hose from Rubber Water facing
drain
plug
is in water is seated to
pan and
THUMB
SCREWS
l
distributor down. reconnected
l
Hose is distributor.
pump
!
l
FIGURE
7
Hose from water bin drain opening.
pan is inserted
2. Remove the �water thumb screws (Figure
pan 71.
by
unscrewing
the
two 9. Reconnect electrical harness. Replace cutter grid.
3. Remove the hose from rhe water pump. Clean the water inlet hose hanging in the water pan.
FIGURE
8
4. Remove the water d,stributor from the freezing plate. It is held in place by rubber end caps. Remove the inlet hose and clean all water distributor holes an@ the small orfice in the inlet side of the distributor. When replacing the distributor, make sure the end caps are located in the evaporator flange detents and that the water distributor holes face down.
5
|
|
|
> |
|
