I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 11 (click to view)
125985340_gb.qxp
2006-08-31
07:43
Page 11
use electrolux 11
programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted. In both cases the light of the Start/Pause button flashes to remind you that the start button needs to be pressed again. Indicator lights These lights indicate the following functions: �Drying� light This light indicates that the appliance is in the drying phase. �Cooling� light This light indicates that the appliance is in the cooling phase. At the end of drying, there is a 10 minute cooling phase to cool the laundry. �End of programme� light This light is on at the end of the cooling phase, during the anti-creasing phase and at the end of the programme. �Filter cleaning� light It comes on every 80 cycles to remind you that the condenser must be cleaned. At the end of the programme All drying programmes end with a 10 minute cooling phase. If the laundry is not removed at the end of the cycle, the dryer performs an anti-creasing phase (duration: 30 minutes maximum). If you do not remove the laundry, the dryer will stop automatically at the end of the anti-creasing phase. Lights end and filter remain lit and the buzzer sounds for 2 minutes. Turn the programme selector dial to �0�;
all the lights go out. The appliance is switched off. Remove the laundry. If you open and then close the door before turning the selector dial to �0� all the indicator lights come on. After each use � Clean the filters.
Important!
GB
If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position Cooling and wait until the end of this cooling phase before removing the laundry. This will avoid a build-up of heat inside the appliance.To do this first turn the dial to �O� and then to Cooling O and depress Start button. Modifying the programme To change a programme which is running, first cancel it by turning the programme selector dial to �O�. Select the O new programme and press the Start button .
