|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Was very fast and accurate service. Just what I needed. I recommend to everyone.
 ;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
1-2.
Removal of the Punch Unit
1. Remove the Upper Cover. 2. Unplug two connectors.
4643D002AA
3. Remove two screws and the Punch Unit.
4643D003AB
NOTE When reinstalling the Punch Unit, ensure that part A of the gear on the Finisher fits into the slit in the gear of the Punch Unit. Clutch
4643D018CA
1-3.
Removal of the Stapling Unit
1. Holding both sides of the cover, lift the cover up and take it off.
4643D004AC
2. Remove one screw and remove the Stapling Unit from the moving cradle. 3. Remove the screw, unplug the connector, and remove the Stapling Unit.
4643D005AG
D-2
|
|
|
> |
|
