|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual was a good representation of service infomation for the EWV404. It worked well for my repair.
 ;
Great quality copy, right what I was looking for, all I need to fix my radio.
Thanks
;
I BOUGHT A PAIR OF INFINITY VINTAGE SPEAKERS THAT REQUIRED TO BE REPAIRED AND THE ELECTRONIC TECHNICIAN ASKED ME FOR THE SERVICE MANUAL.
I TRIED TO GET IT AT THE MANUFACTURER'S SITE WITH NO SUCCESS, SO I STARTED TO LOOK FOR IT IN THE WEB FOR A LONG TIME, UNTIL I FOUND THE SERVICE MANUAL IN THIS EXCELLENT SITE "OWNER'S MANUAL.COM".
NOW I HAVE MY SPEAKERS WORKING AND ENJOYING THE MUSIC I LIKE.
THANKS TO "OWNER`S MANUAL.COM" I RECOMMEND THIS SITE TO EVERYONE.
;
Very quick response. Very good and accurate print quality of the scanned document.
;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
Wiring of the circuit power supply (2/2) Lock the CNPOW, TSW, and FG3 by passing them through hole indicated in the through the power supply case fastener. diagram below. Make sure to pass the CNSH2 Wiring of the circuit power supply board (1)Style the CNPOW, TSW, and FG3. (2)Attach the CNSH2 [CAUTION] (3)Attach the power supply sheet. Make sure to attach the power (4)Style the CNPWR.
Fastener CNSH2.
TSW supply sheet after attaching the
CNPOW FB5 Power supply case
CN102 Power supply sheet Pass the CNPWR through FG1 sheet, and pull the wire out.
FG3
hole in the power supply CN103 Circuit CN101
FB2
F
C104
When pulling out the CNPWR and supply FB2, make sure that they do not pass over the C104 (electrolytic capacitor), CNSH2 E2 as this will cover the anti-explosion valve on top of the capacitor.
Fasten the CNSH2 and E2 with
power
1 B
ED-X8255(CC9XMN)
34
ZTP2 View from CNPWR
Clamp power supply case.
[CAUTION] As upper case touches the gray areas of diagram on the right, make
C104 tape, ZTP1 and ZTP2, after pass-
above C104 ing them through clamps of the
View from sure no wires protrude into these areas. Power supply the side
Power supply sheet Louver of
C104
C104 the power
supply case Correct
case holes
Incorrect
Don�t wire E2 on the louvers. Fasten E2 with ZTP1. Make sure to stick the tape The solid line in diagram indicates an example correct wiring. along outline of the power supply case holes as shown ZTP1 The dotted lines in the diagram indicate examples of incorrect wiring. in the diagram.
Outline of (solid line) power supply Correct Incorrect
(dotted line)
Wiring diagram 2
|
|
|
> |
|
