as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Exactly as described, the full user-manual (145 pages). Perfect.
Text excerpt from page 5 (click to view)
INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING � The hood support surface must be 135 mm above the bottom surface of the wall units. � Drill the support with a ø 4,5 mm drill bit, using the drilling template provided. � Cut a hole ø 125 mm in size on the support surface, using the drilling template provided. � Fix using the 4 screws 12a (4,2 x 44,4) provided.
12a
125
135
264 15 502 - 8 02 Vf
SNAP-ON FITTING � The hood can be installed either directly on the bottom surface of the wall units (min. 650 mm above the hob) using snap-on side supports. � Cut a fitted opening in the bottom surface of the wall unit, as shown. � Insert the hood until the side supports snap into place. � Lock in position by tightening the screws Vf from underneath the hood.
CLOSING ELEMENT � The space between the edge of the hood and the rear wall can be closed by applying the element 20 provided, using the screws supplied for this purpose.
