This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 5 (click to view)
INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING � The hood support surface must be 135 mm above the bottom surface of the wall units. � Drill the support with a ø 4,5 mm drill bit, using the drilling template provided. � Cut a hole ø 125 mm in size on the support surface, using the drilling template provided. � Fix using the 4 screws 12a (4,2 x 44,4) provided.
12a
125
135
264 15 502 - 8 02 Vf
SNAP-ON FITTING � The hood can be installed either directly on the bottom surface of the wall units (min. 650 mm above the hob) using snap-on side supports. � Cut a fitted opening in the bottom surface of the wall unit, as shown. � Insert the hood until the side supports snap into place. � Lock in position by tightening the screws Vf from underneath the hood.
CLOSING ELEMENT � The space between the edge of the hood and the rear wall can be closed by applying the element 20 provided, using the screws supplied for this purpose.
