This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
The owner's manual was evetything I thought it would be. I was able to print it out using both sides of the paper in quick order, saving me a search online for a used one.
Fantastic quality and impressive delivery time. Based on this manual, I recommend this service without hesitation! Five Stars for certain.
Text excerpt from page 11 (click to view)
Wiring Diagram
N
220 240 0 1 2 3 4
2
1
A. IGNITOR SWITCH B. IGNITOR UNIT
L
Brown
Fault Finding
Preliminary Electrical Systems Check
Blue Green Yellow PLUG (with cover removed) Earth Wire Green/Yellow
()
FUSE
SOCKET (face view)
E( )
START Isolate appliance and carry out: A: Earth Continuity check.
Neutral Wire Blue
N
L
Blue Brown Green Yellow
NO
YES
Carry out: C: Polarity check.
Carry out: D: Resistance to Earth check.
Electricity supply should now be satisfactory.
Has inlet fuse blown?
NO
YES
A. EARTH CONTINUITY CHECK - Appliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjust zero if necessary. a) Test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 W (Ohm), check all earth wires for continuity and all contacts are clean and tight. B. INSULATION CHECK - Appliance electrically disconnected, all switches ON. a) meter set on W (Ohms) x 1 scale. Test leads from L to N in appliance terminal block. If meter reads «0» then there is a short circuit. b) meter set on W (Ohm) x 100 scale. Repeat test with leads from L to E. If meter reads less than ¥ (infinity) there is a fault. NOTE - Should it be found that the fuse has failed but no fault is indicated - a detailed continuity check (i.e. by disconnecting and checking each component) is required to trace the faulty component. It is possible that a fault could occur as a result of local burning/arcing but no fault could be found under test. However a detailed visual inspection should reveal evidence of burning around the fault.
Inlet wiring faulty. Rectify any fault.
Isolate appliance and carry out: B: Insulation check. Rectify any fault including replacing fuses as necessary.