|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual was destroyed and this purchase made it possible to recover my manual . It was easy to down load and smooth to use thanks .
 ;
Turns out this was not the manual i was looking for. The concertmate 670 keyboard i have is a "Realistic" model made for Radio Shack and none of the diagrams on the owners manual i received matches up. HOWEVER, I must say the service Owners Manual provides was fast and efficient by being available online. The manual was in good readable condition and easily downloaded.
 ;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
 ;
Thank´s for your help, I already recived these manual from you
 ;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
Install properly..
Install defrost drain coveI:..
I. Remove cover from literature package. 2. Check drawing on page 2 for placement. 3. Install cover.
Clean it ...
Clean your freezer before using it. See cleaning instructions on page 6.
1. Check the strength of the floor. It should hold the weight of a fully loaded freezer.
2. Pick a safe place, indoors, away flammables such as gasoline.
from in-
3. Allow at least 3 inches (7.5 cm) air space on all sides of freezer and 2 inches [5 cm] at back. Leave room at top for lid to open all the way. 4. It should not be necessary to remove the lid during installation. If, for any reason, the hinges need adjustment, see your authorized WHIRLPOOL dealer. 5. Do not cover the treezer wtth items such as
Plug it in...
3-prong grounding type wall receptacle RetainiFg Clip
blankets,
sheets, tablecloths,
etc.
Level chest freezer...
from end to end and front to back so that the lid will seal properly Check with level Freezer / Power Plug w .I�� Recommended J-prong grounding-plug Method
Grounding
Remove sales labels...
Remove any labels before using the freezer.
A 115Volt,60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle
To remove any remaining OR
glue:
I. Rub briskly with thumb to make a ball, then remove. 2. Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water) before removing glue as described in step 1.
which cannot be turned off with a switch or pull chain. Do not use an extension cord.
Attach retaining clip over power cord plug from literature package inside the freezer. See individual electrical requirements and grounding instruction sheet in your literature package.
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, carbon tetrachioride, etc. These can damage the material. NOTE: DO NOT REMOVE the Tech Sheet on inside of compressor compartment door.
4
|
|
 |
> |
|