Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Text excerpt from page 11 (click to view)
Installation
The hob must be installed according to the instructions supplied. The hob must be installed by qualified personnel to the relevant British Standards. Please, ensure that, once the hob is installed, it WHEN THE HOB IS FIRST INSTALLED Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Rectangular cut-out size for hob
is easily accessible for the engineer in the event of a breakdown.
Cut Out Size
The dimensions of the cut-out are given in the diagram.
Supply connections
This hob is designed to be connected to 230-240 V (50Hz) electricity supply. The hob has a terminal block which is marked as follows: L N or E - Live terminal - Neutral terminal - Earth terminal
.
FO 2098
4 7 0
550
5 m i n
Dimensions are given in mm.
The cable used to connect the hob to the electrical supply must be 6mm, PVC twin and earth, and fused to 30amp. It is necessary that you install a double pole swith between the hob and the electricity supply (mains), with a minimum gap of 3mm between the swith contacts and of a type suitable for the required load in compliance with the current rules. The switch must not break the yellow and green earth cable at any point.
30
1
ON/OFF SWITCH
FLEX OUTLET
Building In
Building over a cupboard or drawer
If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2.
FLEX OUTLET
FO 0763
