WHIRLPOOL EJT161XKWR2
Owner's Manual

Adjusting

the Shelves

and Meat Pan.

Tilt the Front Lift the Back

Arrange your refrigerator shelves and meat pan to suit yourself. You can put two shelves together to make one full-width shelf, or put them on different levels. To remove them, tilt up at the front. Then lift up at the back. When replacing them, keep them tilted; guide the rear hooks Into the slots in the shelf bracket. Lowerthe front. Before moving the meat pan itself, remove the pan by pulling it out, lifting the front and then pulling out the rest of the way

Reversing

the Door Swing.

You can change the hinges on Your refrigerator so the doors open the other way If you rearrange Your kitchen or move your refrigerator to a new kitchen. You might like Your doors to open the other way Refer to the enclosed instruction sheet.

Removing
, Push in the Center; Pull Down

the light

Shield.

You may want to remove the light shield when cleaning, or for changing the bulb First, unplug the refrigerator. Then, push lightly on the upper center of the shield until the notched tab is free from the console. Pull down until the tab clears, then lift the back hooks out of their slots To replace It. do the reverse

Removing

the Crispers

and Crisper

Covers.

Push the lab to Clear the Cover

To remove the crrspers, slide them out until they stop. Lift the front a little and slide them the rest of the way out. Each cover IS held In place by two pegs at the back and two notched tabs in the front Press the tabs out of the way to lift the front Lift the back off the pegs. To put the covers back, replace the center leg Replace each cover by first fitting the back notches over the pegs Then push the front down into the notched tabs. The center leg can be made shorter or longer to help level the crrsper covers, if necessary. Turn the leg clockwise to make it longer. Turn It counter-clockwrse to shorten it

ICE MAGIC�
Snap Back Into Place

Automatic

Ice Maker.

Raise Signal Arm to Stop Ice Lower Signal Arm to Star] It

If you have the automatic ice maker accessory or plan to add one later(PartNo.ECKMF-6),thereareafewthingsyouwilIwantto know: l The ON/OFF lever is a wire signal arm. Down...for making ice automatically; Up...to shut off the ice maker. l Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity. l It is normal for ice crescents to be attached by a corner.They will break apart easily l You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you. l The ice maker will not operate until the freezer is cold enough to make ice.This can take overnight. . Because of new plumbing cor,nections, the first ice may be discolored or off-flavored. Discard the first few batches of ice. l If ice is not being made fast enough and more ice is needed, turn theTemperature Control toward a higher number. Waita day and,if necessary, turn the Air Control toward A. . If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position. . If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation. 5

Maker