Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
Good quality instructions manual. Very useful to me. Quick and excellent service from Owner-Manuals... Thanks !!!
Text excerpt from page 17 (click to view)
Operation stop In order to set an operation stop, the mode button has to be pressed repeatedly until the LED is flashing. Then the desired operation stop (time frame between time-of-day + 1 minute and time-of-day minus 1 minute) can be set using the plus and minus buttons. Once adjusted it will be stored after approx. 5 seconds, and the LED remains illuminated steadily. The display reverts to the time-of-day. As soon as the operation stop has been reached, the relay opens and the alarm signal sounds (4 beeps) and the LED is flashing. Pressing any of the buttons stops the signal and the flashing, the LED goes dark and the relay closes again.
Using the Hob
The Hob Burners
The symbol on the knob corresponds to a symbol on the control panel (See description of appliance). Off Maximum level Minimum level Use the maximum level for boiling and the minimum for simmering. Always choose positions between the minimum and maximum, never between maximum and off.
Ignition of the burners
� Push the knob and turn it left to the symbol �big flame�. � At the same time the sparker generator begin to produce a spark. � Release the knob after 10 seconds and watch that the burner has ignited (until the safety valve automatically keeps the burner lit). � Upon ignition, adjust the flame as required. OR Power Cut � Push the corresponding knob in completely and turn it left to the symbol �big flame� and ignite with a match. � Release the knob after 10 seconds and watch that the burner has ignited (until the safety valve automatically keeps the burner lit). � Upon ignition, adjust the flame as required. If for any reason the flame should extinguish turn off the relevant control knob, leave for at least one minute and then re-ignite. If after a few attempts the burner does not ignite, check that the burner ring and its cap are correctly positioned. Extinguishing of burners Turn the knob clockwise to mark « ».
