I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Text excerpt from page 15 (click to view)
Gas oven burner nozzle
1. Nozzle replacement
To replace the gas oven nozzle, follow this procedure: a) remove the bottom of the oven; b) undo screw 1 (fig. 20) and take the oven burner out; c) with a socket spanner 7 unscrew and remove the nozzle, situated in the bottom of the oven, and replace it with the proper one (see Technical data); d) reassemble the burner following the same procedure backwards.
2. Minimum level adjustment of gas oven burner
After setting the oven on maximum temperature with closed door for about 10 minutes, turn the knob of the thermostat on minimum. To reach the thermostat by-pass screw and adjust the minimum level, act as follows: � take out the knobs; � remove the front panel; � in case of conversion from natural gas to LPG, tightly screw the by-pass screw of thermostat (fig. 21); � converting from LPG to natural gas, unscrew the by-pass screw, until a regular small flame is reached. � finally check that turning quickly the tap from maximum position to minimum position, the flame does not go out; � reassemble the front panel and the knobs. The oven burner do not need any primary air regulation.
