|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
;
I got the manual quickly after the payment was transfered (1 day). The manual was exactly what i needed and the updates via e-mail were great. Thanx!
;
I've looked for this manual all over that internet, you guys had it and to a good price. A++++
;
I've looked some time for this manual, you guys had it and to a good price. A++++
 ;
factory technician level - complete with board views :
( removing chassis from cabinet , only thing missing ) ;
on weekends , staff is not available so - be patient .
Mechanical instructions
EM5E-DVD
4.
EN 15
1
CL 26532086_025.eps 050702
CL 16532021_012.eps 300301
Figure 4-4 DVD-tray release catch.
Figure 4-6 Cable routing 1
1
CL 16532021_013.eps 300301
CL 26532086_026.eps 050702
Figure 4-5 DVD fixation screws. 4.1.4 DVD Eject Switch � To access the DVD eject switch, unscrew the two fixation screws and pull the switch out of the cabinet. Remove the switch cable if necessary. The switch panel can now be removed. To reassemble the switch, make sure that the cable is fixed before mounting.
Figure 4-7 Cable routing 2.
�
4.1.5
Attention Point � The routing of some cables is very critical. So therefore, take care that the cables are routed as shown in pictures hereunder. Not routing the cables in this way can cause problems like picture disturbance and EMC problems. � Routing of the cable between LSP connector 1936 and DVD Interface connector 0240 (blue 11-pins cable): guide the cable as close as possible to the SSB shielding en than between the cable relief of the scavem-assy (Auto-scavem board itself is not present in EM5E-DVD), and from there to the DVD-interface. (See figure �Cable routing 1�) � Routing of speaker cable and top control cable: make sure this cables are routed between the DVD lock plate and the DVD board. Also make sure to guide them underneath the two flat foil cables. (See Figure �Cable routing 2.�)
|
|
|
> |
|
