The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Text excerpt from page 29 (click to view)
CLEANING THE SHELVES, WIREWORK RUNNERS AND GRILL/OVEN FURNITURE
All removable parts, except the grill pan handle, can be washed in the dishwasher. The grill pan, grill pan grid, oven shelves and wirework runners may be cleaned using a soap impregnated steel wool pad. Soaking first in hot soapy water will make cleaning easier.
Fit the new bulb by turning in a clockwise direction until it is secure. Ensuring the indent to the flange is pointing to the rear of the oven, replace the glass by pushing it firmly into the hole to cover the bulb assembly. Replace the shelves and wirework runners. Restore the electricity supply and adjust the time of day and clock as necessary.
TO REMOVE THE WIREWORK RUNNERS
The wirework runners in the grill and oven cavities can be removed for cleaning. 1. Remove all shelves and furniture from the grill and oven compartments. 2. Hold the wirework at the bottom, unclip from the cavity side and gently pull towards the centre of the grill or oven compartment. 3. Unhook the runner at the top and remove from the cavity.
SIDE PANEL CAVITY CENTRE
CLEANING THE DOOR GLASS
To prevent damaging or weakening the door glass panels avoid the use of the following: · Household detergents and bleaches Impregnated pads unsuitable for nonstick saucepans Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers Bath/Sink stain removers · ·
4. To replace, hook the wirework runner back into the grill/oven sides. Ensure that the wirework runners are firmly in place before refitting the oven shelves.
· · ·
REPLACING THE OVEN LIGHT BULB
The type of bulb required is a 300°C 25 watt small Edison Screw. Part number 572 491 5431-00/1 (Available through your local Service Force Centres). The main oven and second oven inner door glass panels are removable for cleaning. Under no circumstances should the door assembly be detached from the product for cleaning. Please refer to the cleaning instructions.
CAUTION:
DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE BULB. Open the door and remove the shelves and wirework runners to enable easy access to the oven light assembly. Insert a flat blade screwdriver between the oven side and glass which covers the bulb. Support the glass with your hand and prise out sufficiently to release the glass cover. Unscrew the bulb in an anticlockwise direction until it is possible to remove the bulb with ease.
