|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good scan quality, only PC Board scan not enough contrast.
;
First of all I must say that I received the manual in just a few minutes after placing the order. The copy is well done and very readable. I will buy others soon... Thanks, Meyer
 ;
Good service manual. I gat all I want. Copy is good, but could be better. All clear and useful. I sincerely recommend.
;
The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.The schematic is very helpful and the images are very good.
;
Welcome. The scheme is clearly helped me to repair. Worth to download it.
9-6. Toner Replenishing Control 1. The ATDC Sensor installed in the Imaging Unit reads the toner-to-carrier ratio of the developer in the Developer Mixing Chamber for each copy cycle. 2. It samples the ratio 16 times and compares each with the preset level. 3. If eight or more readings out of the total 16 are lower than the preset level, a Toner Replenishing signal is output. 4. Toner Replenishing Motor M8 is turned one complete turn for each Toner Replenishing signal (which is equivalent to a supply of 0.45 g toner). * The readings taken while M8 is turning (it takes 5 seconds for M8 to turn one complete turn) are ignored. This means that, in a multi-copy cycle, the ATDC Sensor may take readings as the next copy cycle is started while M8 is turning; but, those readings are ignored.
1142C09MAA
M-28
|
|
|
> |
|
