|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
 ;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
;
It's a grate service manuals.Have many details and the writing it's so clear.You have all you want in manual,nothing missing,belive me.I'm verry satisfied of this manual.
operation Massage head adjustment button to DOWN. 2. Install a washer and a spring to the guide roller G in the left side and mount the massager on the lowest position of the back frame.
3. Turn the hex nut M6 counterclockwise and move the massager upward. 4. Make sure that the massager has been mounted horizontally by moving the massager to the position shown in the Figure. *Unless the massager has been mounted horizontally, an abnormal sound or problem may occur. 5. Move it up to the highest position (until the massager stops) by setting the controller manual operation Massage head adjustment button to up. 6. Peeping into the square hole of the back frame, check the position of the massager to adjust. *One thread of the up/down detection gear gives a stroke change of 4mm.
When the massager has been raised excessively : Turn the up/down detection gear counterclockwise to adjust.
When the massager has been lowered excessively : Turn the up/down detection gear clockwise to adjust.
While adjusting the distance between the square hole and Guide roller assy. to 10mm, check by using the up/down adjustment button found on the manual operation panel of the controller. 7. Install the rail piece A and B, and tighten uniformly the set screws (left and right, 3 pcs. each). 8. Using the manual operation of the controller, conduct the rolling
23
PDF created with pdfFactory Pro trial version www.pdffactory.com
|
|
|
> |
|
