ELECTROLUX EPSO
Owner's Manual

Conversion from Natural to LPG Gas
IMPORTANT The replacement/conversion of the gas hob should only be undertaken by a CORGI registered engineer. It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted. The gas rate is adjusted to suit. The oven burner does not need any primary air regulation.

Replacement of gas oven burner nozzle

To replace the gas oven nozzle, follow this procedure: a) remove the bottom of the oven; b) undo screw �a� and �b� and take the oven burner out; c) with a socket spanner 7 unscrew and remove the nozzle, situated in the bottom of the oven, and replace it with the correct one (see Table on this page); d) reassemble the burner following the same procedure backwards.

a

b

Minimum level adjustment of gas oven burner
To reach the thermostat by-pass screw and adjust the minimum level, act as follows: � disconnect the appliance; � take out the knobs; � remove the front panel; � in case of conversion from natural gas to LPG, tightly screw the by-pass screw of thermostat (see fig.); � to convert from LPG to natural gas, unscrew the bypass screw, until a regular small flame is reached. � connect the appliance again; � ignite the gas oven burner; � turn the control knob to maximum position for at least 10 minutes; � finally check that turning quickly the tap from maximum position to minimum position, the flame does not go out; � reassemble the front panel and the knobs.

Fig.9

Fig.10

TYPE OF GAS

NOZZLES 1/100 MM

NOMINAL POWER KW

POWER IN 3 m /h

REDUCED POWER g/h (KW)

BY-PASS 1/100 MM

GAS NOMINAL PRESSURE (mbar)

MIN PRESSURE mbar

MAX PRESSURE mbar

Natural gas (G20) Butane (G30) Propane (G31)

114 78 78

2,7 2,5 2,5

257 -

180 180

1,1 1,1 1,1

Reg. 52 52

20 29 37

17 20 25

25 35 45

15