My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
Text excerpt from page 16 (click to view)
Door Reversal
If you wish to change the opening direction of the doors, proceed as follows: 1. Open the freezer door. Remove the plinth (A) at the bottom of the appliance, by pushing downwards and pulling outwards. (See fig 5) 2. Remove the hinge cover (B) in the plinth and reposition on the opposite side of the plinth. 3. Whilst supporting the lower door, use a 8mm nut driver to remove the 4 hinge retaining bolts and remove the lower hinge. 4. Carefully lower the door off the central hinge. 5. Support the upper door and remove the two securing screws from the centre hinge. Remove the hinge, taking care that the upper door does not fall, retain the plastic spacer washer. 6. Carefully remove the upper door. 7. Unscrew the small blanking plugs (3) and refit on the opposite side to cover the vacant hinge holes. 8. Unscrew the hinge pin (4) in the upper and lower hinge blades and refit on the opposite side. 9. Change the door self-closing system (5) by moving the device from the freezer door and viceversa. 10. Refit the spacer washers and the upper door onto the upper hinge pin and refit the centre hinge in position. 11. Relocate the lower door onto the central hinge pin, and refit the lower hinge assembly. 12. Refit the plinth. After reversing the door ensure the internal light turns off when the fridge door is closed, and the door gasket seals correctly to the cabinet. If the gasket is not sealing correctly, apply warm air to the non-sealing area using a hair dryer set to gentle heat. This will make the rubber more supple and allow it to revert to its original shape and seal correctly.
Fig. 8
