Having purchased a 1994 Kenwood music system from a Charity shop in 2013 (it was a high end product in its day), I found myself not quite knowing where to plug in what, and how to do this, that and the next thing. I needed a Manual, and after failure with another online 'Manual provider' I found Owner Manuals dot com. Well, I wasn't sure, but it was only $5, and if things didn't work out, I wouldn't have lost much...
But things DID work out. After paying my childrens inheritance money, $4.99, I was sent a Manual for my Kenwood System very quickly. Alas, it was in German, and being Scottish, I could not read it or get my system in order from it...a rapid email to them brought the English Manual in short order, and my retro-system was and IS up and running in it's regulation settings.
I am very grateful to http://www.owner-manuals.com for their quick service and for even having such an obsolete Manual in the first place! If you need a Manual for ANYTHING, try here first. I wouldn't be surprised if I bought a 1928 Marconi radio, and got the user Manual for THAT here too!
Top marks.
John Copeland
Glasgow
Scotland
I was so happy that the owner's manual was available. It is well written and helped me to use the radio/CD player/recorder without problems. Thanks for making it available.
Irene Lambert
Excellant!!! Very quick and easy....Best $4.99 I have spent in a very long time..
I highly recommend this.
Text excerpt from page 9 (click to view)
Building the appliance in under a worktop
This appliance can also be built in under the worktop of your kitchen unite. To do this, proceed as follows: 1. remove screws which secure the top to the rear brackets; 2. move the top slightly to release it from the retainers and remove it; 3. unscrew the screws securing the rear feet to the cabinet; 4. remove the 3 mm shim from the feet and refit them; screw in the front feet to obtain the required height. Note Hole provided in the top hinges enable the appliance to be secured to the kitchen worktop by means of two screws. Important For the appliance to function properly, an opening of at least 137 cm2 must be cut in the kitchen worktop (see fig.).
A minimum clearance must also be provided between the,condenser and the wall, as shown in the figure.
