ELECTROLUX ER7828C
Owner's Manual

DESCRIPTION OF THE APPLIANCE

Door reversal directions
1. Disconnect from the electricity supply. 2. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing; F E

G E F
F

H

A B C

3. pull off the ventilation grille (D) which is clipped into place;

D
PR18

4. remove the hole cover (G) and the bottom hinge (E) by unscrewing its three fixing screws; 5. Slide out the fridge door from pin (G), unscrew the latter and then refit it on the opposite side; 6. Remove the two screws which mask the holes for fixing the hinge from the left hand side; 7. Reassemble the door; 8. using a 10 mm spanner, unscrew the hinge pin (E) and reassemble it on the opposite side of the hinge; 9. reassemble the lower hinge (E) on the opposite side, using the screws previously removed; insert the hole cover (G) on the lower hinge. Slide the hole cover (F) out of the ventilation grille (D) by pushing it in the direction of the arrow and reassemble it on the opposite side; 10. refit the ventilation grille (D), clipping it into place. 11. Unscrew the handle. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack.

F

G

G

F E

D

Attention
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If A - Dairy compartment B - Movable storage shelf C - Can storage shelves D - Bottle storage shelf E - Salad crisper F - Glass shelf G - Storage shelves H - Thermostat control the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
PR228

4

Printed on recycled paper

17