Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Text excerpt from page 5 (click to view)
EXISTING CONSTRUCTION
ERS 110II, ERS 110DT, ERS 310 ERS 210II, ERS HV250
1. Remove the plastic paint shield from the speaker frame.
2. Determine the correct speaker location. Note: Use the included template when cutting the drywall.
1. Remove the plastic paint shield from the speaker frame.
2. Determine the correct speaker location. Note: Use the included template when cutting the drywall.
�1/2"
�1/2" �1/2" �1/2"
�1/2"
�1/2"
3. Note: Always allow at least one-half inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.
4. Cut the drywall.
3. Note: Always allow at least one-half inch between a wall stud and the speaker cutout or the locking tabs will not be able to swivel into place.
4. Cut the drywall.
5. Connect the speaker wires to the speaker.
6. Place the frame assembly in the wall.
5. Connect the speaker wires to the speaker.
6. Place the speaker assembly in the wall.
7. Screw down each of the four Phillips head screws.The locking tabs will swivel into place and secure the unit to the rear surface of the drywall.
8. Attach the metal grille.
7. Screw down each of the six Phillips head screws.The locking tabs will swivel into place and secure the unit to the rear surface of the drywall.
