|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Adjusting
the crisper
cover
track
Because your crispers are not the same size, your crisper cover has an adjustable center track so you can switch positions of the crispers. You can adjust the center track with the cover in the refrigerator by removing the crispers and the cover insert.
To remove the center track: 1. Push up the cover insert from the bottom,
than slide out with both hands. 2. Gently pull up on front end of track. 3. Pull rear end of track out of opening in cover.
To replace the center track: 1. Insert rear end of track (with hole) into
opening in cover. 2. Lower front end of track into slot. 3. Make sure rear end of track has snapped into place on underside of cover.
Adjusting
the freezer
shelf
Adjust the freezer shelf to match the way you uw your freezer.
To mmovo the shelf: 1. Lii entire shelf slightly.
2. Move shelf all the way to one side. 3. Tilt other side up and out of shetf support 4. Pull shetf up and out.
To replace the sheW: 1. Tilt the shelf ad insert into freezer
compartment. 2. Insert ons end of the shelf all the way into the center of the shelf support cups. 3. Lower other and d shetf and insert into the shelf support cups. 4. Lower shelf into place. NOTE: The shalt should lower slightly and lock into plaoe. If the shelf does not appaar sturdy, make sure both ands of the shelf are inserted into the shelf support cups. 12
|
|
|
> |
|
