|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Adjusting the refrigerator shelves...
Shelves can be adjusted to match the way you use your refrigerator. Glass shelves are strong enough to hold bottles, milk and other heavy food items.
GLASS SHELVES ARE HEAVY. BE CAREFUL.
To remove glass shelves: 1. Tilt up at front. 2. Lift up at back. 3. Pull shelf straight out.
To replace glass shelves: 1. Guide the rear hooks into the slots in the shelf supports. 2. Tilt up front of shelf until hooks drop into slot. Lower front of shelf to level position.
Removing freezer shelf...
1. Lift front slightly. 2. Lift back off supports. 3. Replace in reverse order.
LlFl THE FRONT THEN THE BACK
Adjusting the door shelves...
TO remove
door
shelves:
To replace
door shelves:
1. Lift up shelf. 2. Tilt up at front. 3 PI 111 ch=rf straight out.
1. Tilt up front of shelf until hooks fit into slots in the shelf support. 2. Lower front of shelf to level position. 3. Push shelf down.
,P
I_
!,.:
r%.-.-~~I*---~ 1 i a�
To remove the crispers:
Li, :pIRhvli nyr&
Removing crispers and crisper co;eri::
PULL OUT TO STOP, LIFT THE FRONT AND PULL AGAIN
1. Slide crisper straight out to stop, lift front, then slide the rest of the way out. 2. Replace in the reverse order. To remove the cover: 1. Push up glass insert from bottom, then slide out with both hands. 2. Lift front of cover frame. 3. Lift out cover frame by pulling up and out. 4. Remove metal cover support. To replace the cover: 1. Replace metal cover support on wall supports in front section of cabinet. 2. Fit back of corner into notch supports on walls of refrigerator, then lower into place. 3. Slide back of glass insert into place, then lower front.
REMOVE THE
GLASS IS HEAVY. BE CAREFUL.
|
|
|
> |
|
