|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Changing the light bulbs...
WARNING: Before removing a light bulb, either unplug the refrigerator or disconnect the electricity leading to the refrigerator at the main power supply. Shock and injury can occur electricity remains connected. if
1. Reach 2. Remove 3. Replace
behind
the control
console appliance
to find bulbs bulb.
bulb. with a 40-watt
Ice Compartment Door...
Pull the Ice compartment door bottom and slide it to the rear panel out from the
Ice cube trays...
(Model ET22MK only)
If cubes are not used, they may shrink The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.
To remove
ice:
ends
1 Hold troy at both 2 Slightly tw:st
Automatic
ice maker.. .
l
If you have Model ET22MM and have the automatic ice maker accessory, or If you have Model ET22MK and plan to add one later (Part No ECKMF-83). there are a few things you will want to know: l The ON OFF lever IS a wire slgnal arm Down .for making Ice automatically Up. to shut off the Ice maker l Shake the bin occaslonally to keep cubes separated, and to obtain Increased storage capacity
l
You WIII hear water running when ice maker working You�ll hear ice fall into the bin Don�t these sounds bother you
IS let
l
The Ice maker ~111 not operate until the freezer IS cold enough to make ice This con take overnlght. Because Ice may of new plumbing ccnnectlons, the first be dIscolored or off-flavored Dlscard the of Ice
l
first few batches
l
If ice IS not betng made fast enough and more Ice IS needed, turn the Refrigerator Control toward a higher number Walt a day and, if necessary, turn the Freezer Control toward A If you remove the ice bin, raise the slgnal arm to shut off the Ice maker When you return the bin, push it all the way In and lower the arm to the ON posltlon If cubes are stored too long, they may develop an off-flavor like stole water. Throw them away They WIII be replaced. Cubes In the Ice bin can also become smaller by evaporation Good wafer quality IS important for good Ice quality It IS not recommended that the Ice maker be connected to a softened water supply Water softener chemicals such as salt from a malfunctioning sofiener con damage the Ice maker mold and lead to poor quality Ice If a softened water supply cannot be avoided. then It IS Important that the water softener be well molr>+alned and operatlrg properly 7
It IS normal for rce crescents corner They WIII break apart
to be attached easily On
by a
l
l
l
Arm to Start It.
Raise Signal Arm to Stop Ice Maker
|
|
|
> |
|
