I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 9 (click to view)
Adjusting
the
EZ-TrackTM
refrigerator
shelf
The EZ-Track shelf slides from side to side for more flexible storage in your refrigerator. To slide shelf side-to-side: 1. Lift slightly on shelf front. 2. Slide to desired location. 3. Lower shelf front to level position. NOTE: You do not have to remove small items from the shelf before moving it side-to-side. You may need to remove larger items. /
Lif-l front slightly then slide to new location. Upper channel
To remove
the shelf:
1. Remove all items from the shelf.
2. Hold back of shelf with one hand. 3. Lift front of shelf to 45� angle. 4. Lower shelf slightly to release shelf from upper channel of track. Then pull shelf straight out. NOTE: Shelf is heavy. Make sure you use both hands when removing shelf.
Hold with both hands and lift front to 45� angle.
To remove shelf track: 1. Lift both sides of track slightly. 2. Pull track straight out.
Hold both sides and lift up and out.
To replace shelf track: 1. Guide track hooks into the shelf support slots on the back wall of the cabinet. NOTE: Make sure both track hooks are in slots and that the slots are parallel to each other. 2. Push track backward and down. 3. Check that track is completely seated in the shelf supports.
Make sure both sets of hooks are in support slots.
