PANASONIC ETPKE700
Owner's Manual

Installation (continued)
I Installing the adjustment poles to the attachment plate
Follow the procedure given below to install the adjustment poles to the attachment plate which has been installed to the ceiling.

I Installing the bracket to the LCD projector
Install the LCD projector (sold separately) to the various sections of the bracket by following the procedure below.

Procedure # Insert the end of the adjustment poles into the attachment plate.

Procedure # Place the LCD projector upside down on top of a soft cloth, and turn the adjustable legs to move them to the shortest length.

Projector mount bracket

$ Securely attach the projector mount bracket to the base of the projector with the three accessory screws as shown in the illustration at left.
Secure in 4 places.

Provisionally tighten in 3 places.

$ Turn the adjustment poles clockwise slightly so that the fixing holes are in about the centre of the slots in the attachment plate, and then provisionally tighten three of the accessory hexagonal head screws to secure the adjustment poles in that position.

% Install the safety bracket with the accessory screws (two yellow screws) as shown in the illustration at left.
Safety bracket

Angle adjusting bracketA

& Provisionally install angle adjusting bracket A to the projector mount bracket with four of the accessory hexagonal head screws.
Provisionally secure in 4 places.

8

9