|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was complete and of great quality. Originally a tri-lingual file, I first received only one language. After a note to owners-manuals.com, I quickly received the remaining languages... Great service, definitely worth it.
;
Thank you for providing this manual and at low cost.
The Philips scope is of excellent quality, longevity and build and had a couple of faults
when it was passed to me. Having the CCT diagrams is a blessing.
I have fixed the problems and also modded the scope to my requirements.
I have built a 24v Li-Ion pack for portable use from old but good laptop batts.
it is working beautifully and I am well pleased. Keep up the good work Guys.
 ;
manual was very helpful in learning how to propery use my washer. I could not find this manual anywhere else.
;
Awesome quality manual. You really saved my bacon with this one. Was looking for some specific information with regards to my "new" vintage VCR that didn't come with the owners manual. This site is truely a goldmine of available manuals. The quality of the scans are top notch.
Thank-you so much for this awesome manual. If you're looking for this Sony SL-HF400 owners manual, this is the one you NEED to buy. Definitely worth the money.
;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
41902006F.fm Page 20 Tuesday, May 9, 2006 11:08 AM
INSTALLATION
Assemblage
� � � � �
�
A) Si le plan de travail est en bois, utilisez les étriers, les
attaches à ressort et les vis fournies. Positionnez les 4 attaches (A) sur le cadre du plan de cuisson, dans le siège prévu à cet effet, voir Fig. 1 Mesurez le milieu des parties verticales du cut-out comme le montre la Fig. 2. Positionnez le milieu des étriers (C) sur le milieu du côté mesuré auparavant. La partie supérieure des étriers doit être alignée avec la surface du plan de travail. Fixez à l'aide des 4 vis (B) fournies, sur les orifices prévus à cet effet. Installez le plan de cuisson dans l'orifice en faisant de sorte que les attaches (A) se bloquent dans les crans des étriers (C Fig. 4 et 5).
Fig. 1
A
Fig. 2
C B
Fig. 3
A
Fig. 4
B) Si le plan de travail est en marbre ou autre matériau (plastique, céramique, pierre, etc.), fixez la table de
Fig. 5
cuisson au moyen des étriers code 4819 310 18528. (à commander auprès de du Service Après-vente s�ils ne sont pas livrés avec l�appareil). Insérez la table de cuisson dans plan de travail. Positionnez les étriers (C) comme illustré sur la figure, en tenant compte de l�épaisseur du plan de travail. Vissez les vis (E) dans les orifices (D).
Top min. 20 mm
Top max. 50 mm
� �
�
20
|
|
|
> |
|
