|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
Using your freezer
Setting the temperature control...
To stat-l, turn control to the middle of the dial. This setting is designed to maintain the temperature at or near 0°F (- 17.8 �C] under normal operating conditions. II
Adjusting the temperature control.,
1. Turn control to higher number for colder temperatures. 2. Turn to lower number for less cold temperatures.
Cooling freezer first...
I. Allow freezer to cool 6 to 8 hours before filling with
frozen food.
2. Let it cool overnight before adding large amount of unfrozen food. Note: When freezer is first started, the compressor will run constantly until the cabinet is cooled. It may take up to 6 to 8 hours or longer, depending on room temperature and the number of times the freezer door is opened. After the cabinet is cooled, the compressor will turn ON and OFF as needed to keep the freezer at the proper temperature.
The Power Saving Control...
operates electric heaters. These heaters help prevent moisture from forming on the outside of the freezer when humidity is high. I, Use the OFF setting when humidity is low. 2. Use the ON setting only if moisture forms on the outside of the freezer. I,<..,.,; II.j -,..
Changing the light bulb...
WARNING: To avoid possible shocks, first unplug freezer or turn off electricity leading to freezer at the main power supply.
1. Remove light shield by pulling away from the side wall. 2. Replace bulb with a 40-w& appliance bulb. 3. Replace the light shield. Insert the shield tabs in the wall slots, then press the shield to snap into place. 4. Plug in the power cord.
�7rnJr.i
/_..,_iE..rd
PaI*
Removing the bottom basket...
To remove:
1 Lift up on basket. 2. Pull out.
Lift up Then out
To replace:
1. Insert into rear slides. 2. Lower into place. 3. Push basket into place.
To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock. If the key is lost, contact your WHIRLPOOL dealer for a replacement. Always give the complete model and serial number of your freezer when requesting a replacement key. 5
|
|
|
> |
|
