Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Text excerpt from page 21 (click to view)
Something not working?
Problems which you can resolve yourself.
Problem
� The machine does not start up:
Possible cause
� Check that the door is firmly closed. � Check that the machine is plugged in and that there is power at the socket. � Check that the main fuse has not blown. � Check that the programme selector dial is positioned correctly. � Check that the ON/OFF button has been depressed.
� The machine does not fill:
� Check that the water tap is open. � Check that water is coming out of the tap. � Check that the inlet hose is not squashed or kinked. � Check that the filter in the inlet hose is not blocked. � Check that the door is closed.
� The machine fills then empties immediately: � The machine does not empty and/or does not spin: � There is water on the floor:
� The end of the drain hose is too low. Refer to relevant paragraph in �water drainage� section. � Check that the drain hose is not squashed or kinked. � A programme with the �Anticrease� been selected . � Ckeck that the drain filter is clean. � Too much detergent or unsuitable detergent (creates too much foam) has been used. � Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. � Check that the drain hose is not damaged. option has
� Check that the support feet are resting firmly on the ground and that the lock nuts are securely tightened. � Check that the laundry is evenly distributed in the drum. � Maybe there is very little laundry in the drum.
21
ENGLISH
� The machine vibrates or is noisy:
� Check that all the transit bolts and packing have been removed. � Check that the machine is not resting against anything.
