|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
 ;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
To mount two transmitters into a rack: Place the two transmitters side by side onto a flat surface, their bottom sides facing upwards. Align the connecting plate over the holes in the bottom sides of the transmitters. Secure the connecting plate using eight of the supplied recessed head screws (M 3x6). Hook the two rack mount �ears� of the transmitters. to the front panels
Secure the rack mount �ears� to the transmitters using two of the supplied recessed head screws (M 3x6) respectively. Slide the transmitters into the 19� rack. Secure the rack mount �ears� to the rack. When mounting only one transmitter into a rack, use the connecting bar instead of the second transmitter. Hook the two rack mount �ears� of the transmitter. to the front panels
Secure the rack mount �ears� to the transmitter using two of the supplied recessed head screws (M 3x6) respectively. Secure the connecting bar to one of the rack mount �ears� using two of the supplied recessed head screws (M 6x10). If you are not front mounting the antennas, insert the two covering plugs into the antenna holes of the connecting bar. Slide the transmitter into the 19� rack. Secure the rack mount �ears� to the rack. To mount the transmitter�s antenna connection to the front of the GA 2 rack adapter using the AM 2 antenna mount: Screw the BNC socket of the BNC extension cables to the connecting bar using the supplied plain washer and nut. Connect the BNC connector the rear of the transmitter. to the BNC socket at
Slide the transmitter into the 19� rack. Secure the rack mount �ears� to the rack. Connect the telescopic antenna socket . to the BNC
Pull the end cap to extend the telescopic antenna.
50
|
|
|
> |
|
