Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
Text excerpt from page 7 (click to view)
Installation
Unpacking
All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. Using a spanner, unscrew and remove the two rear bottom screws. Slide out the two plastic pins.
P1128
7. Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet.
P0002
Positioning
Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
P1129
P0001
2. Lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor. 3. Remove the polystyrene block from the bottom of the machine and release the two plastic bags.
1 2 3
P1051
P1124
4. Very carefully slide out the left polythene bag, removing it towards the right and then downwards. 5. Very carefully slide out the right polythene bag, removing it towards the left and then upwards.
Water inlet
Connect the water inlet hose to a tap with a 3/4" thread. Do not use already employed hoses for water connection.
P1088
P1126
P1127
6. Set the machine upright and remove the remaining rear screw. Slide out the relevant pin.
The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.
