This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Exactly as described, the full user-manual (145 pages). Perfect.
Text excerpt from page 20 (click to view)
20 electrolux use
Select the Start/Pause
2:00
Entrando agua
Temp. Centrifug. Opción
20:33
Ok
Time manager
Inicio/Pausa
To start the selected programme, press the �Start/Pause� button; the green pilot light stops flashing. On the display will appear the icon, and alternatively the name and the running phase of the selected programme to indicate that the appliance starts operating and the door is locked. To interrupt a programme which is running, depress the �Start/Pause� button: the green pilot light starts to flash and the icon of the selected programme appears on the display to indicate that the appliance is �paused�. To restart the programme from the point at which it was interrupted, press the �Start/Pause� button again. If you have chosen a delayed start, the machine will begin the countdown. Altering an option or a running programme It is possible to change only the options vizualised on the display by means of and buttons before the programme carries them out. Before you make any change, you must pause the washing machine by pressing the �Start/Pause� button.
Changing a running programme is possible only by resetting it. Turn the programme selector dial to �O� and then to the new programme position, press the �Ok� button to cancel the previous washing programme. The washing water in the tub will not emptied out. Start the new programme by depressing the �Start/Pause� button again. Interrupting a programme Depress the �Start/Pause� button to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme. Cancelling a programme Turn the selector dial to �O� and then in the new selected programme. Press the Ok button to cancel the programme which is running. Now press the Start/Pause button to start the new programme. Opening the door after the programme has started First set the machine to pause by pressing the �Start/Pause� button. The corresponding message will appear on the display. If the door cannot be opened, this means that the machine is already heating, that the water level is above the bottom edge of the door or that the drum is turning. In this case the door can not be opened. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to �O�. After about 3 minutes the door can be opened (pay attention to the water level and temperature!).
