|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
;
Zeer duidelijke afdrukken op A4-formaat , zeer uitgebreide handleiding . Pluspunt ,zeer snelle
respons van jullie , binnen de 24h . Top !!!
;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
;
I was impressed with the quality of service (frequent e-mails to let you know the status of your order), and the speed at which the download became available. The manual was a life saver and was not easy to track down. Thank you for such an excellent service.
;
the manual was just what i wanted it had all the revelent information required to operate the hifi .Iwould use any manual i downloaded for any item which needs a manual
Expedition EX20
Guided Tour
1: Input connector - Use this balanced female XLR connector to route line-level signal into the EX20. 2: Output VU meter - This three-segment bar meter shows the EX20 output level. For optimum signal-to-noise ratio, set the Volume control (see #6 below) so that program material is usually at or around 0 VU, with occasional but not steady excursions to the red �+3 dB� segment. 3: Power switch - Use this to turn power to the EX20 on or off. 4: Voltage selector - Make sure this is set correctly for the country you are in before turning on the power to the EX20. 5: Battery VU meter - If an optional RB 2030 rechargable battery pack is
10
5
0
installed, this meter shows how much battery power remains as it is being charged (Power switch off) or depleted (Power switch on). 6: Volume control - This knob sets the level of the EX20�s built-in power amplifiers.
!
7: Output connector- This balanced male XLR connector carries line-level output signal from the EX20. It is used to send signal to a second EX20 being daisy-chained (see interconnection diagram on the following page) or to an optional EX500 subwoofer. 8: Limiter switch - Use this switch to turn the built-in limiter circuitry on or off. In order to maximize speaker protection, we recommend that this switch be left in the �on� position during normal operation. 9: AC output - A standard AC power outlet. 10: AC input - Connect the supplied heavy-gauge 3-pin �IEC� power cable here.
Interconnecting the EX20
Using one EX20: A single mono signal (bus or aux send) is routed from a mixer to the EX20 XLR input.
5
0
10
!
SAMSON
MMPL2242
MPL2242 MPL2242
8
|
|
|
> |
|
