|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Attaching or removing bit
NOTE: When attaching or removing a bit, disconnect battery pack from tool or place the switch in the center position (switch lock). This tool is equipped with a keyless drill chuck. 1. Attachment Insert the bit and turn the lock collar clockwise (looking from the front) to tighten firmly until it stops clicking.
.ASSEMBLY
Attaching or removing battery pack
1. To connect the battery pack: Insert the battery pack. It snaps into place to indicate proper connection. 2. To remove the battery pack: Press the two buttons on the sides of the battery pack. Slide the battery pack out of the tool body.
Support handle
Place the support handle at your favorite position and tighten the handle securely.
2. Removal Turn the lock collar counterclockwise (looking from the front), then remove the bit.
Lock collar
Loosen
Tighten
Remove the handle when placing the tool in the storage case.
.OPERATION
3. Storage Keep the bit in bit holder when not in use. Remove the battery pack to expose the bit storage compartment inside the handle housing. Bits up to 50 mm (1-31/32 inch) long can be stored here. NOTE: If excessive play occurs in the chuck, secure the drill in place and open the chuck jaws by turning the lock collar and tighten the screw (lefthanded screw) with a screwdriver by turning it counterclockwise (viewed from the front).
Switch Operation
1. The speed increases with the amount of depression of the trigger. When beginning work, depress the trigger slightly to start the rotation slowly. 2. A feedback electronic controller is used to give a strong torque even in low speed. 3. The brake operates when the trigger is released and the motor stops immediately. NOTE: When the brake operates, a braking sound may be heard. This is normal.
Forward / Reverse lever Operation
(Forward ( ), Switch lock, Reverse ( ))
-7-
|
|
|
> |
|
