|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
LED light
CAUTION:
The built-in LED light is designed to illuminate the small work area temporarily. Do not use it as a substitute for a regular flashlight, since it does not have enough brightness. Forward Reverse Depress the trigger switch, then LED light turns on. When the trigger switch is released, the light turns off automatically. The light illuminates with very low current, and it does not adversely affect the performance of the driver during use or its battery capacity.
How to use the belt hook
WARNING:
� Be sure to attach the belt hook securely to the main unit with the screw firmly fastened. When the belt hook is not firmly attached to the main unit, the hook may depart and the main unit may fall. This may result in an accident or injury. � Be sure to attach the belt hook firmly and securely onto a waist belt or other belt. Pay attention to the unit not slipping off from the belt. This may result in an accident or injury. � When the main unit is held by the belt hook, avoid jumping or running with it. Doing so may cause the hook to slip and the main unit may fall. This may result in an accident or injury. � When the belt hook is not used, be sure to return it to the storing position. The belt hook may catch on something. This may result in an accident or injury. � When the unit is hooked onto the waist belt by the belt hook, do not attach driver bits to the unit. A sharp edge object, such as a drill bit, may cause injury or an accident.
3. Release the belt hook lock lever to lock the angle of belt hook.
4. Make sure the belt hook is firmly locked. To return the belt hook to the storing position, Follow step 1. and 2. above, then lower the belt hook. To secure the lock, follow 3 and 4 above.
Switch lock
To change the belt hook location side
The belt hook can be attached to either side of the unit.
CAUTION:
To prevent damage, do not operate Forward/Reverse lever until the bit comes to a complete stop.
To set the belt hook angle position
1. Slide the belt hook lock lever # and hold it to unlock the belt hook
1. Set the belt hook at storing position. 2. Loosen the screw turning it counterclock-wise, using a coin or a flat blade screw driver
$ #
3. Take out the belt hook and insert into the other side of the slot on the main unit 4. Fasten the screw firmly, turning it clockwise The belt hook can be taken out from the main unit only when it is at storing position.
storing position
CAUTION
To eliminate excessive temperature increase of the tool surface, do not operate the tool continuously (using two or more battery packs consecutively.) Tool needs cool off time before switching to another pack.
2. Pull the belt hook from storing position $ and set it as desired angle
�8�
�9�
|
|
|
> |
|
