The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Text excerpt from page 28 (click to view)
Operating Instructions
Starting a dishwashing cycle
0 1. Check that dishes and cutlery are arranged in the dishwasher so that
the spray arms can turn freely. 2. Turn the water tap on fully. 3. Press the ON/OFF button. The LED indicators of all the buttons on the control panel that can now be selected light up. 4. Press the programme button for the required cycle (see �Cycle table�). The programme indicator comes on. The remaining time expected for the cycle will be shown in the multidisplay.
3
This remaining time may be adjusted according to the size of the load, degree of soiling, etc. 5. Close the dishwasher door. The dishwasher cycle starts. A light signal in the form of a dot appears at floor level. If the dishwasher is built in at high level with flush fitting cupboard doors, the light signal cannot be seen. The dot shaped light signal is not dangerous. (It is not a laser.) It is lit while a dishwasher cycle is running and goes out when the cycle ends. If after the start of the cycle fault codes are displayed in the multi-display and/or acoustic fault codes can be heard, please read the section �What to do, if ��
3 3 3
Changing/interrupting/cancelling a dishwasher cycle
3
Only change or interrupt a dishwashing cycle that is in progress if it is absolutely necessary. After the appliance is closed again, the air that has entered is heated up to a high degree and expands. This can allow water into the bottom reservoir and may trigger the anti-flood system. Changing a dishwasher cycle
3
If you want to change the dishwasher cycle before closing the dishwasher door, briefly press the button for the new dishwasher cycle. If you want to change the dishwasher cycle after the cycle has started, proceed as follows:
