|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good information with clear drawings. Thanks!
 ;
The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
;
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
;
I am proud of you. In the future, I benefited from your services.
;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
TROUBLESHOOTING SERVICE CALL CONDITIONS
July 30th, 1996
Symptom: Fusing Unit Failure (Error Code 9-22) This error occurs in any of the following conditions: � When the fusing temperature is below 90° C and does not increase at least 20° C within 12 to 30 seconds after the lamp turns on. � If the fusing temperature does not exceed 157 °C within 60 seconds after the lamp turns on. � If the fusing temperature drops below 70 °C when low temperature mode (100 °C ) is selected in the power saver mode. � If the fusing temperature drops below 145 °C while printing. � If the fusing temperature exceeds 200 °C for more than 50 ms. Action: Before checking anything, do the following. Reset the RAM address 8002DC(H) to 00(H), then switch the power off, wait for a few seconds, then switch back on. If the problem remains, check the following points. 1. Check if ac power is supplied to the lamp from the PSU or not. If not, replace the PSU. 2. Check the connection between the PSU and the fusing lamp. 3. Check if the thermistor is shorted or not. If it is, replace the thermistor. 4. Check the connection between the MCB (CN2) and the thermistor. 5. Replace the fusing lamp, thermistor, and/or PSU.
Symptom: Mirror Motor Failure (Error Code 9-23) This error occurs in either of the following conditions: � When the line synchronization signal is not detected within 1 second of the mirror motor being turned on. � When the motor rotation is not within 8431.7 rpm ± 5% at 4.2 seconds after the motor turns on or if the motor is not within 8431.7 rpm ± 3% for more than 0.5 second during mirror motor operation. Action: 1. Check the connection between the MCB (CN10) and the square mirror motor. 2. Replace the square mirror motor. 3. Replace the MCB.
Symptom: Fusing Unit Fan Motor Failure (Error Code 9-34) This error occurs in either of the following conditions: � When the voltage of the fusing unit fan motor drops below 160 mV for more than 2 seconds while turning. Action: 1. Check the connection between the MCB (CN11) and the fusing unit fan motor. 2. Replace the fusing unit fan motor. 3. Replace the MCB.
7-20
|
|
|
> |
|
