|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
(8)
For the FAX-270MC/290MC/520DT/520MC/MFC370MC/390MC: Take out the microphone* and its harness* from the control panel.
Bosses
Main-mike harness*
Latches
Control panel
* Provided on the FAX-270MC/290MC/520DT/520MC/ MFC370MC/390MC.
(9)
To take out the LCD, remove the control panel PCB and the FPC key in step (6). As shown below, insert the tip of a flat screwdriver under clamp �D� in the direction of arrow F and push up clamp �D� slightly to release the LCD from clamp �C.� In the same way, insert the screwdriver under clamp �A� to release the LCD from clamp �B.� Then push out the LCD with your fingers in the direction of arrow R.
F
"A" Flat screwdriver
R
"B"
LCD F (Rear) "C" R "D"
s Reassembling Notes � To put the LCD back into place, insert the tip of a flat screwdriver under clamp �D� (see the above illustration) in the direction of arrow R, push up clamp �D� slightly, and then put the right edge of the LCD under clamp �D.� In the same way, insert the screwdriver under clamp �A� to put the left edge of the LCD under clamp �A.� Then push the LCD into place with your fingers in the direction of arrow F. � � When installing the LCD, take care not to scratch or damage the cover sheet. Replace it if scratched or damaged. A new LCD is covered with a protection sheet. Before installing it, remove the protection sheet.
IV � 12
|
|
|
> |
|
