|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
fast response great copy easy to download quick to correct mistakes
;
This manual provided the necessary information to properly use the C-3 deck. The manual was an excellent reproduction and very clear.
;
Product was very good. Received quickly and complete
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
Important The centre hinge can be moved horizontally by about 3 mm to allow alignment of the doors, as follows: slacken the two screws securing the centre hinge to the cabinet and move the hinge until the doors are in line. Re-tighten the hinge securing screws. Warning Once the opening direction of the doors has been changed, check that the magnetic seal adheres to the cabinet. If the ambient temperature is cold (for example in winter), the seal may not adhere perfectly to the cabinet. In this case, wait for the seal to adapt naturally to its new position, or accelerate this process by heating up the area involved with a normal hairdryer.
Warning A top seal is supplied loose with the appliance; this seal must be �tted before inserting the appliance into the recess (the holes for �xing it are pre-drilled). A plastic edging strip, with a double-sided adhesive strip on the inner side, is also supplied.
Fig. 3
Remove the backing from the edging strip, then stick it vertically onto the front edge of the appliance, on the side on which the door opens (Fig. 3). Fitting this strip eliminates any gaps between the edge of the appliance cabinet and the inside of the kitchen unit recess.
D030
Building and securing the appliance into the tall kitchen unit
Recess height 1446 mm Recess depth 550 mm Recess width 560 mm
Fitting the appliance into the recess (Fig. 4) To position and secure the appliance inside the recess, proceed as follows:
Fig. 4
Recess characteristics (Fig. 1-2)
Fig. 1 50 8
The dimensions of the recess for �tting the appliance
A
position the appliance inside the tall kitchen unit, pushing it against the inner side of the unit on which the door opens (Fig. 4); make sure that, with the door closed, the appliance is set back 8 mm from the
into a tall kitchen unit must be as indicated in the table above. 200 cm Ventilation is provided though the bottom grille, se25 D140 cured to the bottom of the appliance, and through an opening to be cut in the base of the kitchen unit (minimum size 200 cm2 2
A
D117
front of the recess (Fig. 1). Using the 6 screws provided, secure the bottom ventilation grille and the top seal (the holes are pre-drilled).
Fig. 1).
Fig. 2
0 54
50
A vent outlet, 50 mm deep by 540 mm wide must be cut in the top of the unit (Figs. 1-2)
L P H
D010
14
|
|
|
> |
|
