I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 22 (click to view)
Replacing
1. Make sure all surface units are off and
cool before replacing surface units and reflector bowls.
2. Llns up openings in the reflector bowl with the surface unit receptacle and the element holcldown clip.
3. Hold the surface unit as level as possible
with the terminal just started into the receptacle. Push the surface unit terminal into the receptacle.
4. When terminal is pushed into the receptacle as far as it will go, push down the edge of the surface unit
opposite the receptacle. The element hold-down clip will keep the surface unit from moving around. NOTE: Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer. If a reflector bowl gets discolored, some of your utensils may not be flat enough, or some may be too large for the surface unit. In either case, some of the heat that�s meant to go into or around a utensil goes down and heats the reflector bowl. This extra heat can discolor it.