|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
High-quality scanning. Detailed description. Recommend for all technician. A+++
;
This is a good quality scan of the original Service Manual from Nordmende, Germany. Contains the circuit diagram, PCB layout, adjust/tune instructions as well. It is NOT in English but in GERMAN language! That was quite right for my german friend from the lower east side in Berlin.
 ;
Received via e-mail this PDF manual is worth the money. This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand. I have later seen the original manual and it was printed in colour, but this particular manual is black & white but scan resolution is high end quality! All drawings and pictures are presented in great detail. So, nearly perfect score in my opinion.
If you own the turntable you also should own the manual!
;
I was very satisfied with the service manual I ordered and downloaded. I will definitely buy again from this seller.
;
Great product. Recieved it fast...exactly as advertised.
FH-2816ZF,2716ZF
7.2.2 DISASSEMBLY
- Removing the Case(Not shown)
1. Insert and turn a flat screwdriver to remove the case. Keyboard Unit
- Removing the Grille Assy and Keyboard Unit
1. Press the four tabs and Disconnect the connector indicated by arrow and then removing the Grille Assy. 2. Removing the Knob Unit. 3. Removing the five screws and then removeving the Keyboard Unit. CAUTION: Remove the Knob Unit before removing the screws that secure the Keyboard Unit. Do not hold CN901 by hand when removing the Keyboard Unit from the grille. Be careful not to bend the connector teeth when installing the grille to the product. Be sure to insert the insulator into the Grille Assy.
Knob Unit
Grille Assy
- Removing the Heat Sink
1. Removing the five screws and then removing the Heat Sink. Heat Sink
A
- Removing the CD Mechanism Module and Chassis Unit
1. Removing the four screws A.
B
B
CD Mechanism Module
A
A
2. Disconnect the connector and then removing the CD Mechanism Module. B 3. Removing the six screws B and then removing the Chasis Unit. CAUTION: Plug the Fuji Card into the card connector of the CD mechanism or main unit at an angle of 60 degrees.
A
Chassis Unit
B B B
90
|
|
|
> |
|
