|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service was good but it just a little late for the download. It seems that it needs to clear the payment but the payment was settled by paypal. As far as my concern, it should be able to download after the confirmation of sold.
;
Great quality manual, fast service, excellent seller... Thanks !!!
;
Great manual and fast service. Download was possible after a few hours.
;
thanks a lot.
without the service manual my handycam was going to the trash.
good job, go on.
bye
 ;
This service manual is a good copy of the original, complete and fully readable. It is really useful to repair my Tv set following its clear instructions.
FH-MG6406ZH
- How to remove the Pickup unit
1. Remove the pulling spring, torsion spring and Eshaped ring. Then remove the Clamper arm. * The spring (A) will be removed with the Clamper arm. Pulling spring E-shaped ring Clamper arm
Torsion spring
Fig.7 2. Slide the Clamp UP lever (B) to remove it. 3. Loosen the 2 screws. Remove the feed-screw cover by sliding it. 4. Remove the feed-screw pressure spring (D). 5. Loosen the 2 screws. Remove the feed-screw holder (E). 6. Remove the belt. 7. Remove the Pickup unit together with the feed screw. * Be careful not to lose the shaft holders at the both ends of the feed screw. * Be careful not to damage the 2 flexible PCBs(for the Pickup and motor) when separating them. The flexible PCBs have been stuck each other with doublesided adhesive tape.
Carriage motor Pickup unit
Black White
Belt
Feed screw
Fig.8
8. Loosen the 2 screws. Remove the plate spring and the rack. 9. Pull out the feed screw from the Pickup unit. Grease (Yellow: PG-641) Feed screw
Plate spring Rack Grease (White: KD-1) Grease (Yellow: PG-641)
Pickup unit Fig.9
75
|
|
|
> |
|
