ZANUSSI FJD1466W
Owner's Manual

PREWASH WASH RINSES

S TA RT/PA U S E

SPIN DRAIN

The SKIP button is then used to cancel or advance the programme to the required phase. The SKIP button can only operate when the programme is in pause. A normal wash cycle consists of the following phases, Wash - Rinses - Spin and is confirmed by the illumination of the corresponding LED,s.
PREWASH WASH RINSES SPIN DRAIN

11 DELAY button
This button makes it possible to delay the starting of the programme by up to 24 hours. The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears. If the button OUTDOOR SPORTS has been pressed the selected delay will correspond to the soak time. If no delay time is selected the soak programme will last about 30 minutes. You must select this option after you have set the programme and before you press the START/PAUSE button. The time value shown on the display will decrease by one unit every hour. You can change the delay time at any moment, before you press the START/PAUSE button. If you have already pressed the START/PAUSE button, and you wish to change or cancel the delay time, proceed as follows: � set the washing machine to PAUSE by pressing the START/PAUSE button; � press the DELAY button until the display shows the desired delay time or � press the DELAY button once, to erase the delay time. The display will indicate �0h�. � press the START/PAUSE button again. Important! The door will be locked throughout the delay time (DOOR LOCKED light lit). If you need to open the door, you must first set the washing machine to PAUSE by pressing the START/PAUSE button. After you have closed the door, press the START/PAUSE button again.

To select rinses & spin, the programme must be paused, now press the SKIP button once, the wash LED goes out.

PREWASH WASH RINSES SPIN DRAIN

To select spin only, the programme must be paused, now press the SKIP button twice. The wash & rinsess LED,s go out.
PREWASH WASH RINSES SPIN DRAIN

12 Programme phase indicator lights
When you select a programme, the lights relevant to the phases that form the programme light up. After you have started the programme, only the light relevant to the phase that is currently being carried out will remain lit. 9

To select Drain the programme must be paused, now press the SKIP button three times, the wash - rinses spin LED,s go out.