ZANUSSI FJS1084C
Owner's Manual

Something not working?
Problems which you can resolve yourself.

Problem
� The machine does not start up:

Possible cause
� Check that the door is firmly closed. � Check that the machine is plugged in and that there is power at the socket. � Check that the main fuse has not blown. � Check that the programme selector dial is positioned correctly. � Check that the ON/OFF button has been depressed.

� The machine does not fill:

� Check that the water tap is open. � Check that water is coming out of the tap. � Check that the inlet hose is not squashed or kinked. � Check that the filter in the inlet hose is not blocked. � Check that the door is closed.

� The machine fills then empties immediately: � The machine does not empty and/or does not spin:

� The end of the drain hose is too low. Refer to relevant paragraph in �water drainage� section. � Check that the drain hose is not squashed or kinked. � A programme which ends with water in the drum has been selected. � Check that the filter is clean.

� There is water on the floor:

� Too much detergent or unsuitable detergent (creates too much foam) has been used. � Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. � Check that the drain hose is not damaged.

� The machine vibrates or is noisy:

� Check that all the transit bolts and packing have been removed. � Check that the machine is not resting against anything. � Check that the support feet are resting firmly on the ground. � Check that the laundry is evenly distributed in the drum. � Maybe there is very little laundry in the drum.

20