|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very helpfull
circuit diagram and sparepart list available
 ;
Very good reproduction (copy) of original manual. Didn't have a parts list, but schematic was completely labeled with parts. Complete instructions on how to adjust mechanical functions of the 8-track deck. Well worth having and at a very reasonable cost.
;
It's a full manual. All the parts are in there. I haven't found the problem yett, but I am working on it; hope I can rebuild the part myself. To make it more secure and unbreakable this time. Because the part has failed several times before and costs a lot to let it be repaired.
Thanks so much for this rich illustrated and parted manual.
;
I downloaded the document. The manual was complete, well scanned and everything was legible. I could zoom in see what I needed to know. There's not much more that you can ask.
;
It was complete service manual with all needed service informations. Thanks.
4. MECHANICAL ADJUSTMENTS
1. MECHANICAL CHECKS
If irregular operation occurs or when reassembling a part, please check the following. 1) Make sure that the datum hole of the RELAY PLATE meets that of the MAIN BASE in the Eject Mode as shown in Fig. 4-1. 2) Make sure that the datum hole of the CAM GEAR meets that of the MAIN BASE in the Eject Mode as shown in Fig. 4-1. 3) There are two triangle mark in the MODE SWITCH. When installing the L/C BRKT ASS'Y, make sure that the one marks meets the other in the Eject Mode as shown in Fig. 4-2. 4) Make sure the that the BOSS of the PINCH LEVER ASS'Y is located outside of the CAM of the CAM GEAR in the Eject Mode as shown in Fig. 4-2. 5) Make sure that the datum hole of the MAIN PLATE meets that of the MAIN BASE in the Eject Mode as shown in Fig. 43. 6) When installing the RELAY GEAR, make sure that the triangle mark meets the last groove of the teeth of the MAIN PLATE in the Eject Mode as shown in Fig. 4-3. 7) Make Sure that the triangle mark of the L LOADING GEAR ASS'Y meets the -Shaped mark of the R LOADING GEAR ASS'Y in the Eject Mode as shown in Fig. 4-4. 8) Make sure that the 1'st tooth of the R LOADING GEAR ASS'Y meets the 1'st groove of the LOADING GEAR ASS'Y in the Eject Mode as shown in Fig. 4-4.
31
|
|
|
> |
|
