|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
this Manual very important when i buy this Manual i already fix the trouble of my Camera..... thanks keep up the good work.!
 ;
This service manual helped me to repair my PIONEER. Iam very satisfied, that I found it here.
Even the price of manual was not so high that person would not be able to spend a few money.
But that is very worth spent money. Thanks
;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
4. MECHANICAL ADJUSTMENTS
1. MECHANICAL CHECKS
If irregular operation occurs or when reassembling a part, please check the following. 1) Make sure that the datum hole of the RELAY PLATE meets that of the MAIN BASE in the Eject Mode as shown in Fig. 4-1. 2) Make sure that the datum hole of the CAM GEAR meets that of the MAIN BASE in the Eject Mode as shown in Fig. 4-1. 3) There are two triangle mark in the MODE SWITCH. When installing the L/C BRKT ASS'Y, make sure that the one marks meets the other in the Eject Mode as shown in Fig. 4-2. 4) Make sure the that the BOSS of the PINCH LEVER ASS'Y is located outside of the CAM of the CAM GEAR in the Eject Mode as shown in Fig. 4-2. 5) Make sure that the datum hole of the MAIN PLATE meets that of the MAIN BASE in the Eject Mode as shown in Fig. 43. 6) When installing the RELAY GEAR, make sure that the triangle mark meets the last groove of the teeth of the MAIN PLATE in the Eject Mode as shown in Fig. 4-3. 7) Make Sure that the triangle mark of the L LOADING GEAR ASS'Y meets the -Shaped mark of the R LOADING GEAR ASS'Y in the Eject Mode as shown in Fig. 4-4. 8) Make sure that the 1'st tooth of the R LOADING GEAR ASS'Y meets the 1'st groove of the LOADING GEAR ASS'Y in the Eject Mode as shown in Fig. 4-4.
31
|
|
|
> |
|
